Datasheet

Safety Data Sheet
Material: 60083223 WACKER® SILICONE PASTE P 250
Version: 1.1 (REG_EUROPE) Date of print: 21.10.2013 Date of last alteration: 13.12.2012
Page: 2/7
SECTION 4: First aid measures 4.
4.1
Description of first aid measures
General information:
In case of accident or if you feel unwell seek medical advice (show label or SDS where possible).
After inhalation:
Material cannot be inhaled under normal conditions.
After contact with the skin:
Wipe off excess material with cloth or paper. Wash with plenty of water or water and soap. In the event of a visible skin change or
other complaints, seek medical advice (show label or SDS where possible).
After contact with the eyes:
Rinse immediately with plenty of water. Seek medical advice in case of continuous irritation.
After swallowing:
Give several small portions of water to drink. Do not induce vomiting.
4.2
Most important symptoms and effects, both acute and delayed
Any relevant information can be found in other parts of this section.
4.3
Indication of any immediate medical attention and special treatment needed
No data are available.
SECTION 5: Firefighting measures 5.
5.1
Extinguishing media
Suitable extinguishing media:
water spray , extinguishing powder , alcohol-resistant foam , carbon dioxide , sand .
Extinguishing media which must not be used for safety reasons:
water jet .
5.2
Special hazards arising from the substance or mixture
-
5.3
Advice for firefighters
Special protective equipment for fire fighting:
Use respiratory protection independent of recirculated air.
SECTION 6: Accidental release measures 6.
6.1
Personal precautions, protective equipment and emergency procedures
No special measures required.
6.2
Environmental precautions
Prevent material from entering sewers or surface waters.
6.3
Methods and material for containment and cleaning up
Scoop up large quantities after dusting surfaces with sand or Fuller's earth to prevent sticking. Sweep or scrape up the spilled
material and place in an appropriate chemical waste container. Clean any slippery coating that remains using a detergent / soap
solution or another biodegradable cleaner. Apply sand or other inert granular material to improve traction.
6.4
Reference to other sections
Relevant information in other sections have to be considered. This applies in particular for information given on personal
protective equipment (section 8) and on disposal (section 13).
SECTION 7: Handling and storage 7.
7.1
Precautions for safe handling