Datasheet

Safety Data Sheet (1907/2006/EC)
Material: 60083223
WACKER® SILICONE PASTE P 250
Version: 2.2 (GB) Date of print: 24.05.2017 Date of last alteration: 22.06.2016
Page: 2/8
After contact with the skin:
Wipe off excess material with cloth or paper. Wash with plenty of water or water and soap. In the event of a visible skin change or
other complaints, seek medical advice (show label or SDS where possible).
After inhalation:
Material cannot be inhaled under normal conditions.
After swallowing:
Give several small portions of water to drink. Do not induce vomiting.
4.2
Most important symptoms and effects, both acute and delayed
Any relevant information can be found in other parts of this section.
4.3
Indication of any immediate medical attention and special treatment needed
Further toxicology information in section 11 must be observed.
SECTION 5: Firefighting measures
5.
5.1
Extinguishing media
Suitable extinguishing media:
water mist , extinguishing powder , alcohol-resistant foam , carbon dioxide , sand .
Extinguishing media which must not be used for safety reasons:
water jet .
5.2
Special hazards arising from the substance or mixture
Risk of hazardous gasses or fumes in the event of fire. Exposure to combustion products may be a health hazard! Hazardous
combustion products: carbon oxides , silicon oxides , incompletely burnt hydrocarbons , toxic and very toxic fumes .
5.3
Advice for firefighters
Special protective equipment for fire fighting:
Use respiratory protection independent of recirculated air. Keep unprotected persons away.
SECTION 6: Accidental release measures
6.
6.1
Personal precautions, protective equipment and emergency procedures
Secure the area. Wear personal protection equipment (see section 8). Keep unprotected persons away. If material is released
indicate risk of slipping. Do not walk through spilled material.
6.2
Environmental precautions
Prevent material from entering surface waters, drains or sewers and soil. Close leak if possible without risk. Retain contaminated
water/extinguishing water. Dispose of in prescribed marked containers. Inform authorities if substance leaks into surface waters,
sewerage or ground.
6.3
Methods and material for containment and cleaning up
Scoop up large quantities after dusting surfaces with sand or Fuller's earth to prevent sticking. Sweep or scrape up the spilled
material and place in an appropriate chemical waste container. Clean any slippery coating that remains using a detergent / soap
solution or another biodegradable cleaner. Apply sand or other inert granular material to improve traction.
6.4
Reference to other sections
Relevant information in other sections has to be considered. This applies in particular for information given on personal protective
equipment (section 8) and on disposal (section 13).
SECTION 7: Handling and storage
7.
7.1
Precautions for safe handling
Precautions for safe handling:
Observe information in section 8.
Precautions against fire and explosion:
Observe the general rules for fire prevention.