Datasheet

Safety Data Sheet (1907/2006/EC)
Material: 60003095
WACKER® SILICONE PASTE P 12
HEAT SINK COMPOUND
Version: 4.3 (GB) Date of print: 26.03.2019 Date of last alteration: 06.06.2018
Page: 4/9
Hand protection
Use of protective gloves is recommended when handling the material.
Recommended glove types: Protective gloves made of nitrile rubber
thickness of the material: > 0,1 mm
Breakthrough time: > 480 min
Recommended glove types: Protective gloves made of butyl rubber
thickness of the material: > 0,3 mm
Breakthrough time: > 480 min
Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves.
Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion,
and the contact time. Note that, due to the numerous external influences (such as temperature), a chemically resistant protective
glove in daily use may have a service life that is considerably shorter than the measured break through time.
8.2.2
Exposure to the environment limited and controlled
Prevent material from entering surface waters, drains or sewers and soil.
8.3
Further information for system design and engineering measures
Observe information in section 7. Observe national regulatory requirements.
SECTION 9: Physical and chemical properties
9.
9.1
Information on basic physical and chemical properties
Property:
Value:
Method:
Appearance
Physical state / form ............................................. :
paste
Colour ................................................................... :
white
Odour
Odour ................................................................... :
odourless
Odour limit
Odour limit :
no data available
pH-Value
pH-Value .............................................................. :
not applicable
Melting point/freezing point
Melting point / melting range ................................ :
not applicable
Initial boiling point and boiling range
Boiling point / boiling range .................................. :
not applicable
Flash point
Flash point ............................................................ :
not applicable
Evaporation rate
Evaporation rate ................................................... :
no data available
Upper/lower flammability or explosive limits
Lower explosion limit (LEL) .................................. :
not applicable
Upper explosion limit (UEL) .................................. :
not applicable
Vapour pressure
Vapour pressure ................................................... :
not applicable
Solubility(ies)
Water solubility / miscibility ................................... :
virtually insoluble at 20 °C
Vapour density
Relative gas/vapour density ................................. :
No data known.
Relative Density
Relative Density ................................................... :
2,1 (25 °C; 1013 hPa)
(Water / 4 °C = 1,00)
(ISO 1183-1 A)
Density ................................................................. :
2,1 g/cm³ (25 °C; 1013 hPa)
(ISO 1183-1 A)
Partition coefficient: n-octanol/water
Partition coefficient: n-octanol/water ..................... :
No data known.