Datasheet

Safety Data Sheet (1907/2006/EC)
Material: 60003739 ELASTOSIL® A33
IVORY
Version: 1.9 (REG_EUROPE) Date of print: 19.02.2010 Date of last alteration: 03.12.2009
Page: 2/6
4.3 After contact with the skin
Wipe off excess material with cloth or paper. Remove contaminated or soaked clothing. Wash off
with plenty of water or water and soap immediately for 10-15 minutes. In serious cases, use
emergency shower immediately. Seek medical advice and clearly identify substance.
4.4 After contact with the eyes
Rinse immediately with plenty of water for 10-15 minutes. Keep eyelids well open to rinse the
whole eye surface and eyelids with water. Seek medical advice and clearly identify substance.
4.5 After swallowing
If conscious, give several small portions of water to drink. Do not induce vomiting. Seek
medical advice and clearly identify substance.
4.6 Advice for the physician
After inhalation: treat as early as possible using cortisone spray.
5 Fire-fighting measures
5.1 Suitable extinguishing media
water mist , extinguishing powder , alcohol-resistant foam , carbon dioxide , sand .
5.2 Extinguishing media which must not be used for safety reasons
water spray , water jet .
5.3 Special exposure hazards arising from the substance or preparation itself, combustion products,
resulting gases
Hazardous combustion products: nitrous gases .
5.4 Special protective equipment for fire fighting
Use respiratory protection independent of recirculated air.
6 Accidental release measures
6.1 Personal precautions
Wear personal protection equipment (see section 8). Avoid contact with eyes and skin. Avoid
inhaling mists and vapours. If material is released indicate risk of slipping.
6.2 Environmental precautions
Prevent material from entering surface waters, drains or sewers and soil. Contain any fluid
that runs out using suitable material (e.g. earth). Retain contaminated water/extinguishing
water.
6.3 Methods for cleaning up
Do not flush away with water. For small amounts: Absorb with a liquid binding material such as
diatomaceous earth and dispose of according to local/state/federal regulations. Contain larger
amounts and pump up into suitable containers. Clean any slippery coating that remains using a
detergent / soap solution or another biodegradable cleaner.
7 Handling and storage
7.1 Handling
Precautions for safe handling:
Avoid formation of aerosols. In case of aerosol formation special protective measures are
required (exhausting by suction, respiratory protection). Ensure adequate ventilation. Avoid
contact with acids. Spilled substance increases risk of slipping.
Precautions against fire and explosion:
Observe the general rules for fire prevention. Cool endangered containers with water.
7.2 Storage
Conditions for storage rooms and vessels:
none known
Advice for storage of incompatible materials:
not applicable