Operators Manual

Transport to work site/Recommendations on compaction
T00968GB.fm 24
3. Transport to work site/Recommendations on compaction
3.1 Transport to work site
Conditions:
∗ To transport the vibration plate, only use suitable lifting equipment with
a minimum load-bearing capacity of 150 kg.
∗ During transport, always switch the engine off!
∗ Only attach suitable tackle at the central lifting point (9) provided.
∗ When transporting the machine make sure it is tied down. As fixing
points front handles (10) may be used. Do ensure that the machine
cannot tilt over by threading the rope through the upright handle.
Do not suspend from the guide handle!
Note: Also observe the regulations in the chapter “safety
instructions“.