Operators Manual
Table Of Contents
- 1. Foreword
- 2. Safety information
- 3. Technical data
- 4. Description
- 5. Transport to the worksite
- 6. Operation
- 6.1 Adjusting the handle
- 6.2 Adjusting the guide wheel
- 6.3 Cutting depth setting
- 6.4 Depth of cut indicator
- 6.5 Water tank
- 6.6 Parking brake
- 6.7 Assembling the cutting blade
- 6.8 Disassembling the cutting blade
- 6.9 Checking the motor before starting
- 6.10 Starting the engine
- 6.11 Operating the engine
- 6.12 Turning off the engine
- 7. Maintenance
- 8. Signs
- EC Declaration of Conformity
- DIN EN ISO 9001 Certificate
Maintenance
T01072en.fm 30
7.6 Idle setting
∗ Start the engine and let it warm up to its normal operating temperature.
∗ Adjust the idle speed limiting screw while the engine is running in order
to reach the prescribed idle speed.
Prescribed idle speed: 1,400 ± 150 rpm.
7.7 Tightening the belt
Check the belt in the course of the weekly engine maintenance and re-
tighten it as follows, if necessary:
1. Remove the belt guard.
2. Loosen the jam nut (1).
3. Loosen the four fastening nuts of the engine until the engine can be
moved without play.
2 Idle speed limiting screw