Operators Manual
Table Of Contents
- 1. Foreword
- 2. Safety information
- 3. Technical data
- 4. Description
- 5. Transport to the worksite
- 6. Operation
- 6.1 Adjusting the handle
- 6.2 Adjusting the guide wheel
- 6.3 Cutting depth setting
- 6.4 Depth of cut indicator
- 6.5 Water tank
- 6.6 Parking brake
- 6.7 Assembling the cutting blade
- 6.8 Disassembling the cutting blade
- 6.9 Checking the motor before starting
- 6.10 Starting the engine
- 6.11 Operating the engine
- 6.12 Turning off the engine
- 7. Maintenance
- 8. Signs
- EC Declaration of Conformity
- DIN EN ISO 9001 Certificate
Operation
T01109en.fm 25
6.10 Starting the engine
The cutting blade must not be in contact with the ground.
1. Open the fuel tap (3).
2. Set the choke lever (4) to the CLOSE position.
Please note: Do not use the choke if the engine is warm or the air tempera-
ture is high.
3. Push the throttle lever (2) slightly to the front.
4. Switch the main switch (1) to "I".
5. Pull the starter handle slowly until you feel resistance and then pull
the handle fully out with force.
Caution: Do not suddenly let go of the recoil starter handle but guide it back
gently by hand to prevent damage to the starter.
3
2
4