Operators Manual
Table Of Contents
- 1. Foreword
- 2. Safety information
- 3. Technical data
- 4. Description
- 5. Transport to the worksite
- 6. Operation
- 6.1 Adjusting the handle
- 6.2 Adjusting the guide wheel
- 6.3 Cutting depth setting
- 6.4 Depth of cut indicator
- 6.5 Water tank
- 6.6 Parking brake
- 6.7 Assembling the cutting blade
- 6.8 Disassembling the cutting blade
- 6.9 Checking the motor before starting
- 6.10 Starting the engine
- 6.11 Operating the engine
- 6.12 Turning off the engine
- 7. Maintenance
- 8. Signs
- EC Declaration of Conformity
- DIN EN ISO 9001 Certificate
Operation
T01109en.fm 21
6.6 Parking brake
6.6.1 Integrated parking brake
The machine features an integrated parking brake.
The front wheels are automatically blocked in transport position
(lowest cutting position without a cutting blade) or if the maximum
cutting depth is exceeded.
6.6.2 Manual parking brake (accessories)
Press the pedal (1) down to block the right rear wheel. Push the pedal
upwards for brake release.
Check the tight fit of the parking brake and the setting of the pressure
screw (2) at regular intervals. The brake must securely block the wheel
at least on a 10° slope. Adjust the pressure screw if necessary.