Operators Manual
Table Of Contents
- 1. Foreword
- 2. Safety information
- 3. Technical data
- 4. Description
- 5. Transport to the worksite
- 6. Operation
- 6.1 Adjusting the handle
- 6.2 Adjusting the guide wheel
- 6.3 Cutting depth setting
- 6.4 Depth of cut indicator
- 6.5 Water tank
- 6.6 Parking brake
- 6.7 Assembling the cutting blade
- 6.8 Disassembling the cutting blade
- 6.9 Checking the motor before starting
- 6.10 Starting the engine
- 6.11 Operating the engine
- 6.12 Turning off the engine
- 7. Maintenance
- 8. Signs
- EC Declaration of Conformity
- DIN EN ISO 9001 Certificate
Transport to the worksite
T01111en.fm 16
5. Transport to the worksite
Requirements:
∗ When transporting the floor saw, use only suitable hoisting gear with a
minimum load-bearing capacity of 150 kg.
∗ Always turn off the motor during transportation!
∗ Empty the water tank!
∗ Remove the cutting blade prior to transport. Set the lowest cutting po-
sition on the floor saw.
∗ Remove the water tank and attach the hoisting gear on the transport
strap (1) for lifting.
∗ If you transport the floor saw on the cargo area of a vehicle, strap it
down securely on the special safety bar.
∗ Fold the guide wheel to the top and the handles to the front (or the stir-
rup handle to the top).
∗ Handles, guide wheel and other operating controls must not be used
as attachment points.
Note: Also observe the regulations in the chapter Safety information.