Instructions / Assembly

wc_tx004020gb_FM10.fm

PT2 / PT3 Operation

4.9 Starting and Stopping the Machine (Hatz)

Requirements

■ Suction and discharge hoses properly attached and positioned

■ There is fuel in the tank

Starting the

machine

Perform the procedure below to start the machine.

1. Set the engine speed control lever (a) to the 1/2 START or START position, as

desired or necessary.

Note: Starting the engine at a lower speed will help to prevent exhaust smoke.

2. Pull the starter rope (b) lightly until you feel slight resistance.

3. Allow the recoil starter to pull the starter rope back in. This allows the entire

length of the starter rope to be used to start the engine.

4. Grip the starter rope handle with both hands.

5. Pull the starter rope briskly. Repeat until the engine starts.

Note: If after several attempts to start the engine and exhaust begins to emit white

smoke, move the speed control lever to the STOP position. Then, pull the starter

rope out slowly 5 times. Repeat the starting the machine procedure at step 1.

Stopping the

machine

Set the engine speed control lever to the STOP position.

wc_gr012719

1/2

StartStop