Use and Care Manual

wc_tx003296gb_FM10.fm

Rammer

Maintenance

5.12 Replacing the In-Line Fuel Filter Assembly

When

Every 5 months or every 500 hours (whichever comes first)

Requirements

■ Engine stopped

■ Replacement in-line fuel filter assembly

Procedure

Perform the procedure below to replace the in-line fuel filter assembly. The in-line

fuel filter assembly consists of the fuel filter (a) and two hoses (b).

1. Set the throttle to the OFF position. This will close the fuel valve.

2. Remove the clamp (c) and remove the existing in-line fuel filter assembly.

Discard the in-line fuel filter assembly in accordance with local environmental

protection regulations.

3. Re-install the clamp (c) and connect the new in-line fuel filter assembly, making

sure to orient the fuel filter as shown in the illustration.

4. Set the throttle to the IDLE position. This will open the fuel valve.

5. Check for fuel leaks before restarting the machine.

Result

The in-line fuel filter assembly has now been replaced.

wc_gr011599