Use and Care Manual

wc_tx003294gb_FM10.fm

Rammer

Operation

4.4 Position of the Operator

For optimal control, performance, and minimal hand/arm vibration, follow the

guidelines below when using the machine.

Grasp the handle with both hands as shown.

Stand behind the rammer, walking slowly and guiding the direction of travel as the

machine moves forward.

Note: Hand/Arm Vibration (HAV) has been optimized for the hand position shown.

Reported HAV levels are measured at position A in conformance with EN 1033 and

ISO 5349 standards.

4.5 Before Starting

1. Read safety instructions at the beginning of this manual.

2. Make sure that the fuel tank is full.

3. Check engine oil level.

4. Check fuel lines and fittings.

5. Check the air filter.

6. Check the ramming system oil level.

7. Place rammer on loose soil or gravel. DO NOT start rammer on hard surfaces

such as asphalt or concrete.

wc_gr011468