Instructions / Assembly

Operation PD 2A / PD 3A
28 wc_tx001331gb.fm
4.8 Stopping
Procedure Perform the procedure below to stop the machine.
Note: To stop the engine in an emergency, move the engine switch to the OFF
position. In all other circumstances, use the following procedure.
1. Move the throttle lever (c) to “MIN.” position.
2. Turn the engine switch (d) to the OFF position (d
2
).
3. Move the fuel valve lever (a) to the CLOSED position (a
2
).
4.9 Running the Pump
Guidelines Follow the guidelines below when running the pump.
 Run the engine at full speed.
NOTICE: Pump speed must not exceed 60 strokes per minute.
 The pump should begin pumping water within one minute of being started
depending on hose length and height above water. Longer hoses will require
more time.
 If the pump does not prime:
a. check for loose fittings, air leaks, and plugged strainer.
b. stop the engine, remove plug (a), add water, reinstall plug, and restart the
engine.