Instructions / Assembly

PD 2A / PD 3A Operation
wc_tx001331gb.fm 27
4.7 Starting
Requirements  Completed installation procedures
 Engine owner’s manual read and understood
Procedure Perform the procedure below to start the machine.
1. Move the fuel valve lever (a) to the OPEN position (a
1
).
2. Move the choke lever (b) to the CLOSED position (b
1
). If the engine is warm,
the choke lever may be left in the OPEN position (b
2
).
3. Move the throttle lever (c) approximately 1/3 of the way to the “MAX.” position.
4. Turn the engine switch (d) to the ON position (d
1
).
5. Pull the starter rope until the engine starts.
6. Move the choke lever to the OPEN position as the engine warms.
7. Move the throttle to “MAX.” position to run the pump.