Repair manual

Carburetor Overhaul WM 80 Repair
88 wc_tx000522gb.fm
7.6.13 Non-EPA regulated countries only. Press out the main nozzle (zz).
The procedure is now complete.
Reassembly
7.6.1 Align the hole in the main nozzle (zz) with the passage of the high-
speed needle. Press the main nozzle into the carburetor body until the
top of the main nozzle is flush with the carburetor body.
7.6.2 Install the Welsh plug
(z). Tap it in with a flat punch.
7.6.3 Install the high- and low-speed needles (x and y). Note: The high-speed
needle is shorter than the low-speed needle.