Product Manual

wc_tx003606gb_FM10.fm

Operation RD7

Continued from the previous page.

2. Check that the exciter lever (e) is in the OFF position.

3. Set the throttle lever (f) to the high position.

4. Turn the decompression lever (g) until stop (g

) is reached. In this position, the

automatic decompression system is heard to engage.

5. Insert the engine crank (h) into the guide sleeve (j).

6. Stand alongside the engine, facing the back of the machine (k) and grasp the

engine crank with both hands. Turn the engine crank five turns to build up

pressure.

Note: Keep constant contact between the engine crank and the engine during this

process.

7. Turn the engine crank slowly until the pawl engages the rachet, then increase

the turning force to build up speed until the engine starts.

Note: The highest speed must be reached when the decompression lever (g)

returns to the (g

) position.

8. As soon as the engine starts, pull the engine crank out of the guide sleeve.

Note: If the engine begins to run backwards after backfiring (smoke emerges from

air cleaner), release the crank handle immediately and stop the engine.

9. To restart the engine, wait until it has come to a standstill, then repeat the

starting procedures.

10. Disengage the parking brake.

11.Allow the engine to warm up for a few minutes before operating the machine.

Note: Always operate the machine in the operating position.

WARNING

Personal injury hazard. Injury may result if the engine should backfire.

► Stand alongside the engine, facing the back of the machine. Do not stand in any

other position.

► Maintain turning force during the entire hand starting operation.

wc_gr011687