Product Manual

wc_tx003606gb_FM10.fm
44
Operation RD7
4.11 Direction and Speed Control
Introduction Travel direction and speed are controlled by the forward/reverse control lever (a).
Direction From the neutral position:
■ To move forward, push the forward/reverse control lever away from the
operator.
■ To move in reverse, pull the forward/reverse control lever towards the operator.
Speed Speed is varied by the movement of the control lever. The farther the forward/
reverse control lever is pushed in either direction, the faster the roller will travel in
that direction.
wc_gr011674
a
b
b
b
WARNING
Possible loss of machine control. Holding the handle loosely may cause the
machine to pivot rapidly during operation.
► Hold the handle with both hands while operating the machine.
WARNING
Possible loss of machine control. If the linkage separates from the forward/reverse
control lever while the machine is running, the roller could “run away” and cause
injury.
► If the linkage separates, set the throttle control (b) to the OFF/IDLE position.