Product Manual

wc_tx004491en.fm

Operation RD12A/12K

6.10 Starting, Operating, and Stopping the RD12K (Diesel)

Requirements

■ Machine is in serviceable condition and has been properly maintained

■ There is fuel in the tank

Starting the

machine

Perform the steps below to start the machine.

1. Sit in the operator’s seat and fasten the seat belt.

2. Apply the parking brake.

3. Set the forward/reverse control (a) in the NEUTRAL position.

Note: The roller will not start unless the forward/reverse control is in the NEUTRAL

position.

4. Turn the start key (d) to the ON position. The glow plug indicator (f) will

illuminate signifying the glow plugs are on. The glow plug indicator will stay on

approximately five seconds at 0°C (32°F). Do not start the engine until the glow

plug indicator light goes out.

NOTICE: Do not crank the engine ignition switch for more than 15 seconds at one

time. Longer cranking cycles could lead to starter damage.

5. Turn the start key to the START position until the engine starts, then release the

key.

6. Allow the engine to warm up for a few minutes before operating the roller.

This procedure continues on the next page.

DANGER

Asphyxiation hazard. Exhaust gases contain carbon monoxide and can kill in

minutes.

► Do not start the engine in an enclosed space.

wc_gr014718