Product Manual

wc_tx004491en.fm
46
Operation RD12A/12K
6.6 Position of the Operator
Safe and efficient use of this machine is the operator’s responsibility. Full control of
the machine is not possible unless the operator maintains the proper working
position at all times.
While operating this machine, the operator must:
■ Be seated in the operator’s seat facing forward
■ Wear the seat belt, properly adjusted and latched
■ Have both feet on the operator’s platform
■ Have one hand on the steering wheel at all times
■ Have the other hand free to operate the controls as needed
6.7 Mounting and Dismounting the Machine
When climbing on and off the machine, maintain a three-point contact with the
steps and the handholds.
Three-point contact can be:
■ Two feet and one hand
■ One foot and two hands
NOTICE: Do not use the control lever when mounting or dismounting the machine.
Use only the designated handholds on the control column.
6.8 Operator Presence System
The machine is equipped with an “operator presence system.” This system is part
of the seat and senses the weight of an operator in the seat. During operation, the
engine will shut down if the operator leaves the seat when the machine is not in
neutral.
When the operator sits down again, the forward/reverse control must be placed in
the neutral position before the engine can be started.
Note: A one-half second delay keeps the system from tripping when the machine
passes over a bump.
WARNING
Possibility of injury.
► Always wear the seat belt provided when operating the machine.