Product Manual

wc_tx004491en.fm
45
RD12A/12K Operation
Continued from the previous page.
1. Support the upper half of the ROPS (a) using a crane and suitable rigging
capable of supporting 19 kg (42 lbs).
2. Each side of the ROPS is equipped with two locking pins (b) held in place with
two cotter pins (c). Remove the appropriate cotter pins and pull out the
corresponding locking pins.
3. Lift the ROPS into the upright position.
4. Insert the locking pins and secure them with the cotter pins.
5. Tighten the adjusting handle (screw) (d) to reduce vibration.
The ROPS is now in position and ready for service.
Lowering the
ROPS
Follow the procedure below to lower the ROPS.
1. Support the upper half of the ROPS using a crane and suitable rigging capable
of supporting 19 kg (42 lbs).
2. Remove the appropriate cotter pins and pull out the corresponding locking pins.
3. Gently lower the upper half of the ROPS.
NOTICE: When lowering the ROPS, do not drop the upper frame. Sudden impacts
can weaken or damage the ROPS.
4. Insert the locking pins and secure them with the cotter pins.
wc_gr014310
a
b
d
c
a
WARNING
Crushing hazard.
► Do not remove all cotter pins and locking pins from each side of the ROPS at
the same time. One set of cotter pins and locking pins must always remain
installed on each side of the ROPS during the raising process.