Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 99
Continued from the previous page.
11.Remove the five screws (h) securing the shock mount support plate (i) and
remove the shock mount support plate.
12.Remove the fittings (j) from the motor (k). Reuse the fittings on the replacement
motor.
13.Remove the seven screws (l) securing the motor (k) to the drum support (m)
and remove the motor.
Installation Perform the procedure below to remove the drive motor.
1. Using the seven screws (l) install the motor (k) into the drum support (m).
2. Install the fittings (j) into the motor (k).
This procedure continues on the next page.