Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 98
Continued from the previous page.
6. Using two screw-type or hydraulic floor jacks (d) mounted under the machine,
jack up the machine slightly to relieve pressure on the shock mounts.
7. Remove the top three shock mount screws (a
1
, a
2
, a
3
). Jack up the machine
slightly more to relieve pressure and remove the last two shock mount screws
(a
4
, a
5
).
8. Connect an appropriate lift to the lifting point of the drum support.
9. Remove the lower two screws (e) securing the drum support to the frame. In
their place, insert pins (M16x200 screws with head removed).
10.Remove the other two screws. Then, slide and lift the drum support (f) from the
machine. Remove the large spacer and any shims.
Note: If shock mounts are to be replaced, the size and number of shims may
change.
This procedure continues on the next page.