Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 97
8.5 Removing and Installing a Drive Motor
Prerequisites  Two screw-type or hydraulic floor jacks
 Lifting device capable of lifting 226 kg (500 lb)
 Container to collect draining hydraulic oil
 Two M16x200 screws with head removed
Removal Perform the procedure below to remove the drive motor.
1. Position the machine by moving it forward or reverse as needed so that the
shock mount screws (a) are accessible.
2. Remove the hose cover protective plate (b).
3. Label the hydraulic hoses (c) to aid in re-installation.
4. Have a container ready to collect any draining hydraulic oil.
5. Remove the hoses one at a time and plug them as soon as they are free of the
motor. Dispose of collected hydraulic oil according to local environmental
policies.
This procedure continues on the next page.