Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 96
Continued from the previous page.
3. Connect the hydraulic hoses (c) to the servo valve (f) starting with the rear
hoses first. Be sure to connect the hoses in the correct locations. Do not
connect a long hose where a short one should be connected. Torque the fittings
to 40 Nm (29 ft.lbs.).
4. Inspect the seal around the control console and replace the seal if necessary.
5. Reattach the control console cover.
6. Reattach the vandal guard.
Result The steering servo has now been installed.