Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 95
Continued from the previous page.
7. Remove the three longer screws (d) securing the servo valve.
8. Remove the shorter screw (e) and remove the servo valve (f) from the control
console.
Installation Follow the procedure below to install the steering servo valve.
1. Install the shorter screw (e) to the secure servo valve (f) to the tower.
2. Install the three longer screws (d) to secure the servo valve. Torque all screws
to 22.5±2.5Nm (17±2 ft.lbs.).
This procedure continues on the next page.