Repair manual

Troubleshooting the Vibration System RD 27
wc_tx000953gb.fm 74
5.7 Checking the Drum Vibration Solenoid
Prerequisites  Fully-charged battery
 Functioning vibration switch
Procedure Perform the procedure below to check the drum vibration solenoid.
1. Move the key switch to the ON position.
2. Move the forward/reverse lever slightly out of neutral (in either direction).
3. Locate the drum vibration solenoid (a) inside the left corner of the frame.
4. Disconnect the electrical connector from the drum vibration solenoid.
5. Move the drum selector switch to the dual-drum position.
6. Press the vibration ON/OFF switch to activate vibration. If you are unsure
whether the switch is in the ON or OFF position, press it several times.
7. Measure the voltage at the electrical connector. With the vibration mode switch
in the dual-drum position and the vibration ON/OFF switch in the ON position
(activated), 10–13 VDC should be measured.
Does the voltage measure 10–13 VDC?
This procedure continues on the next page.
Yes ____ No ____
Continue. Repair the wiring between the vibration ON/OFF switch and the
vibration drum solenoid.