Repair manual

Troubleshooting the Vibration System RD 27
wc_tx000953gb.fm 68
5.3 Checking the Vibration ON/OFF Solenoid
Prerequisites  Fully-charged battery
 Functioning vibration ON/OFF switch
Procedure Perform the procedure below to check the vibration ON/OFF solenoid.
1. Move the key switch to the ON position.
2. Move the forward/reverse lever slightly out of neutral (in either direction). With
the vibration ON/OFF switch in the ON position (activated), 10–13 VDC should
be measured.
3. Locate the vibration solenoid (a) inside the left corner of the frame.
4. Disconnect the electrical connector from the vibration ON/OFF solenoid.
5. Press the vibration ON/OFF switch to activate vibration. If you are unsure
whether the switch is in the ON or OFF position, press it several times.
This procedure continues on the next page.