Repair manual

Troubleshooting the Engine Start System RD 27
wc_tx000948gb.fm 40
3.7 Checking the Neutral Switch
Prerequisites  Fully-charged battery
 Multimeter
Procedure Follow the procedure below to check the neutral switch.
1. Roll up the boot (c) from the FWD/REV lever.
2. Remove the wires from the neutral switch (d).
3. Check for continuity between the NC terminal and the COM terminal of the
neutral switch in each position of the FWD/REV control lever. See chart.
Does the neutral switch function as stated in the chart?
Result The neutral switch has now been checked. Reassemble the machine.
Position
Continuity between
NC & COM
Forward No
Neutral Yes
Reverse No
Yes ____ No ____
The neutral switch is OK. The neutral switch has failed; replace it.