Repair manual

Troubleshooting the Engine Start System RD 27
wc_tx000948gb.fm 38
3.6 Checking the Neutral Relay
Prerequisites  Fully-charged battery
 Functioning vibration fuse
Procedure Follow the procedure below to check the neutral relay.
1. Remove the control panel (a) from the steering column.
2. Locate the neutral relay (b) and disconnect it.
3. Place the FWD/REV control in the NEUTRAL position.
4. Measure the voltage between wire 374-PK-16 and ground.
Is 10.0–12.5 VDC measured?
5. Measure the voltage between wire 125-OR-16 and ground.
Is 10.0–12.5 VDC measured?
This procedure continues on the next page.
Yes ____ No ____
Continue. Check the neutral switch.
Yes ____ No ____
Continue. Repair wire 125-OR-16.