Repair manual

Troubleshooting the Engine Start System RD 27
wc_tx000948gb.fm 36
3.5 Checking the Start 2 Relay
Prerequisites  Fully-charged battery
 Functioning key switch
Procedure Follow the procedure below to check the start 2 relay.
1. Place the FWD/REV control in the NEUTRAL position.
2. Remove the control panel (a) from the steering column.
3. Locate the start 2 relay (b) and disconnect the connector.
4. Measure the voltage between wire 307-OR-16 at the connector and ground.
Is 10.0–12.5 VDC measured?
5. With the starter key in the START position, measure the voltage across wire
330-YL-16 of the connector and ground.
Is 10.0–12.5 VDC measured?
6. Reconnect the connector.
This procedure continues on the next page.
Yes ____ No ____
Continue. Check the neutral relay.
Yes ____ No ____
Continue. Check condition/continuity of wire 330-YL-16.