Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 161
8.29 Removing and Installing the Hydraulic Manifold
Prerequisites  Machine shut down
 Hydraulic oil cool
Removal Perform the procedure below to remove the hydraulic manifold.
Use the following graphic as reference.
1. Remove the cover from underneath the hydraulic manifold.
2. Disconnect the wiring to the solenoids.
3. Mark, then disconnect, all hoses from the hydraulic manifold (a).
4. Remove fittings from the hydraulic manifold if necessary.
5. If your machine has a flow divider, see step 6. Remove the bolts that hold the
hydraulic manifold to the machine and remove it from the machine.
6. For machines with flow dividers, remove the hoses from the flow divider (b) and
any fittings that may interfere with removal.
7. The hydraulic manifold and the flow divider are assembled to a mounting plate
(c). Remove the screws that hold the mounting plate to the machine and
remove the mounting plate with the hydraulic manifold and the flow divider
attached to it.
Installation Perform the procedure below to install the hydraulic manifold.
1. Install the hydraulic manifold to the machine. If your machine has a flow divider,
see step 2. If it does not, see step 3.
2. Assemble the hydraulic manifold and the flow divider to the mounting plate (c).
Install the mounting plate to the machine with the hydraulic manifold and the
flow divider attached to it.
3. Install any fittings that were removed.
4. Install the hoses.
5. Reconnect the wiring to the solenoids.
6. Install the cover.
Result The hydraulic manifold and flow divider have been installed.