Manualshelf

Repair manual

ManualsBrandsWacker Neuson ManualsPower RollerRD 27-100
151152153154155156157158159160
Disassembly and Assembly RD 27
wc_tx001221gb.fm 158
8.28 Removing and Installing the Forward/Reverse Control (Joystick)
Prerequisites
Machine shut down
Soldering iron and solder
Removal
Perform the procedure below to replace the forward/reverse control (joystick).
1. Remove the screws (a).
2. Lift the assembly (b) from the machine to gain access to the hydraulic fittings.
3. Label, then remove the hydraulic hoses (c).
4. Remove the fittings
(d).
5. Remove the boot (e) from the end of the joystick.
6. Remove the holders (f).
This procedure continues on the next page.