Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 153
Continued from the previous page.
17.Lift the engine approximately 25 cm (10 in.) out of the machine. Then, cut the
cable tie (v) that secures the hydraulic hose.
18.Also cut the cable ties that secure the engine oil drain hose (w).
19.Lift the engine (x) out of the machine.
20.Set the engine on a flat, clean, solid surface. Remove any needed components
from the engine.
Installation Perform the procedure below to install the engine.
1. Install any needed components from the old engine to the new engine.
This procedure continues on the next page.