Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 150
8.27 Removing and Installing the Engine
Prerequisites  The following components removed:
 Hydraulic reservoir
 Drive pump
 Radiator
 Crane and chains capable of lifting 450 kg (1000 lbs.)
Removal Perform the procedure below to remove the engine.
1. Remove the hydraulic reservoir, the drive pump, and the radiator.
2. Disconnect the exhaust pipe (a) and gasket (b) from the engine.
3. Study the routing of the wiring harness (c).
4. Disconnect the wires (d and e) from the alternator.
5. Disconnect the wiring harness from the starter solenoid (e). Also disconnect the
ground strap (f), the red wire (g), and remove the clamp (h).
This procedure continues on the next page.