Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 145
8.25 Removing and Installing the Vibration Pump
Prerequisites  Machine shut down
 Steering pump removed
Removal Perform the procedure below to remove the vibration pump.
1. Remove the steering pump. See Topic Removing and Installing the Steering
pump.
2. Remove the suction hose (a) from the vibration pump (b).
3. Remove the output hose (c).
4. Slide the vibration pump along the long screws and separate the vibration pump
from the spacer (d) and the engine.
5. Remove the upper long screw (e) and pull the vibration pump (b) from the
machine.
Installation Perform the procedure below to install the vibration pump.
This procedure continues on the next page.