Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 143
Continued from the previous page.
5. Remove the fittings from the steering pump in two phases. First, remove the
fittings (e) up to the elbow.
6. Then, remove the elbow (f).
7. Remove the nuts (g) from the long bolts that also hold the vibration pump.
8. Pull the steering pump (c) from the machine.
Installation Perform the procedure below to install the steering pump.
1. Position the steering pump (c) onto the engine.
2. Using the long bolts and nuts (g) that also mount the vibration pump, secure the
steering pump to the machine.
This procedure continues on the next page.