Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 140
8.23 Removing and Installing the Drive Pump
Prerequisites  Machine shut down
 Hydraulic oil drained
Removal Perform the procedure below to remove the drive pump.
1. Drain the hydraulic oil from the hydraulic reservoir.
2. Label, then disconnect the hoses (a) from the drive pump (b).
3. Remove the coil (c) of the solenoid valve.
4. Remove the two screws (d).
5. Pull the drive pump (b) from the machine.
Installation Perform the procedure below to install the drive pump.
This procedure continues on the next page.