Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 136
Continued from the previous page.
6. Lift the ROPS slightly off the machine. Disconnect the wiring (x) from the
rotating beacon, then lift the ROPS up and away from the machine.
7. Using the adjusting lever (z), adjust the seat towards the rear of the machine as
far as possible.
8. Remove the five screws (e) securing the operator platform.
9. Rotate the operator platform towards the front of the machine. Secure the
operator platform (f) in this position.
10.Disconnect the water hose (g) from the filter.
11.Lift the water tank (h) (with hose attached) up and out of the machine.
This procedure continues on the next page.