Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 134
8.20 Removing and Installing the Spray System Pump
Prerequisites  Machine shut down
 Water system drained
Removal Perform the procedure below to remove the spray system pump.
1. Disconnect the electrical connector (a) from the harness.
2. Remove the screws (b) that hold the spray system pump (c) to the machine.
3. Disconnect the hoses from the spray system pump and pull the spray system
pump from the machine.
Installation Perform the procedure below to remove the spray system pump.
Note: New spray system pumps include the four rubber mounts (f).
1. Connect the hoses to the spray system pump (c).
2. Using the two screws (b), attach the spray system pump to the frame.
3. Connect the electrical connector (a).