Repair manual

Disassembly and Assembly RD 27
wc_tx001221gb.fm 132
Continued from the previous page.
3. Insert the outer race of the larger bearing into the hitch casting. Insert the outer
race of the smaller bearing (d) inside the hitch casting (e).
4. Place the hitch casting over the axle. Fill the hitch casting with multipurpose
grease.
5. Install the oil seal (f) as shown.
6. Align the conical washer (g) (apex side towards the spacer) with the spacer (h).
Insert them into the hitch casting and secure with the bolt (i).
This procedure continues on the next page.