Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 117
Continued from the previous page.
7. After the shim arrangement has been determined, route the hydraulic hoses (h
and i) through the drum supports.
8. Using Loctite 243 or equivalent on the screws (c), secure the drum supports,
large spacers, and shims to the machine frame. Torque the screws to 240 Nm
(148 ft.lbs.).
9. Reattach the hydraulic hoses to either the drive motor or the exciter motor.
10.Reset the brake from the manually released position to the spring-activated
position. See section Manually Releasing Parking Brake.
11.Mount the hose protector plates (g) on each drum support.
12.Fill the hydraulic tank. Start the engine and run the unit for a few minutes. Stop
the engine and allow the machine to rest for 10 minutes. Recheck/top off the
hydraulic oil supply.
Result The drum has now been mounted to the machine.