Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 115
Continued from the previous page.
5. Install the outer seal (e), lip-side up, to the exciter-side bearing flange.
6. Using Loctite 243 or equivalent on the four M8 screws (k), secure the coupling
(l) to the exciter shaft. Torque the screws to 30 Nm (22 ft.lbs.). Install the
coupling gear (j).
7. Install the shock mounts. See section Removing and Installing Shock Mounts.
8. Install the shock mount plate (with bearing and shock mounts installed to it) onto
the exciter-side bearing flange.
9. Attach the retaining clip (e).
10.Align the marks (k) made on the bearing cover (l) during disassembly. Using
Loctite 243 or equivalent on the four M16 screws, secure the bearing cover to
the support plate. Torque the screws to 50 Nm (37 ft.lbs.).
Result The drum is now assembled and ready for re-installation.