Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 111
Continued from the previous page.
1. Coat the grease ring (j) with a thin film of grease and install it into the support
plate.
2. Pack the support plate bearing (i) with 60 grams (2 oz.) of grease. Insert the
bearing into the support plate. If necessary, use the bearing cover as a pusher
to install the bearing. Mount the bearing cover with two screws 180° from each
other. Tighten the two screws evenly until the bearing is seated. Tap the bearing
cover if necessary with a rubber mallet. Remove the bearing cover when the
bearing is in place.
3. Press the inner bearing races (g and h) on to the exciter shaft.
This procedure continues on the next page.