Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 107
Continued from the previous page.
8. Remove the seal (h).
9. Make a reference mark (i) on the bearing flange and clean out the drum so that
no dirt will fall into the drum when the bearing flange is removed.
10.Remove the gear (j). Then, remove the inner four screws (k) and remove the
exciter shaft coupling (l).
11.Remove the six screws securing the bearing flange/drum cover (m) and remove
the bearing flange/drum cover. If necessary, remove the plug screws (n) and
insert the pusher screws (o) to push the bearing flange/drum cover loose.
This procedure continues on the next page.