Repair manual

Disassembly and Assembly RD 27

wc_tx001221gb.fm 102

Continued from the previous page.

5. Remove the two screws (h) and remove the exciter motor (i).

Installation

Perform the procedure below to install the exciter motor.

Place the green adapter portion (j) of the coupling onto the end of the

shaft. Insert the exciter motor, gear/shaft-side down. Make sure the gears

of the exciter motor mesh with the green adapter.

2. Apply Loctite 243 or equivalent to the two screws (h) and install the exciter

motor with the two screws. Torque the screws to 40 Nm (29 ft.lbs.).

This procedure continues on the next page.

wc_gr006773