Repair manual

RD 27 Disassembly and Assembly
wc_tx001221gb.fm 101
8.6 Removing and Installing an Exciter Motor
Prerequisites  Machine shut down
 Battery disconnected
Removal Perform the procedure below to remove the exciter motor.
1. Remove the screws securing the hose protective cover (a) and remove the hose
protective cover.
2. Remove the hose clamps (b) securing the exciter motor to the drum support.
3. Have a container ready to collect any draining hydraulic oil. Remove the case
drain hose (c) from the motor. Plug the case drain line to prevent hydraulic
system contamination. Label the two remaining hoses (d and e). Remove the
hoses one at a time. Plug the hoses to prevent hydraulic system contamination.
Dispose of any hydraulic oil according to local environmental policies.
4. Remove the fittings (f and g) from the motor to access the screws (h) securing
the motor. Reuse the fittings.
This procedure continues on the next page.