Operator`s manual

RD 27 Maintenance
wc_tx000426gb.fm 75
All situation requirements cannot be listed. Minimal towing machine
capacity is required on smooth, level surfaces. On inclines in poor
condition or on surfaces in poor condition, maximum towing capacity
is required.
Attach the towing device and machine before you release the brakes.
If the engine is running:
The machine can be towed for a short distance under certain
conditions. The power train and steering system must be operable.
The operator must steer the machine that is towed in the direction of
the tow line.
Ensure that all instructions in this section are followed carefully.
Ensure that all instructions in this section are followed exactly.
If the engine is stopped:
Shutting off the engine will result in the loss of machine steering.
When the engine is stopped, additional steps may be required before
the machine is towed. In order to avoid damaging the power train, the
steering system, and the brakes, which may be inoperable, additional
steps may be required.
5.25.1 Block the drums in order to prevent the movement of the machine. Do
not remove the blocking until the tow vehicle has been positioned and
the tow lines are in place.
5.25.2 Manually release the parking brake. This will prevent excessive wear
and damage to the braking system when towing.
5.25.3 Turn the bypass valve (a) for two full turns in the counterclockwise
direction.
Note: Do not turn the bypass valve further than two turns. When the
bypass valve is turned further than two turns, oil will leak past the
bypass valve.
5.25.4 Attach the tow line to the machine at the tow points (b & c).
5.25.5 Attach the tow line to the vehicle that is used to tow the disabled
machine.
5.25.6 Remove the blocks from the drums.
5.25.7 Tow the disabled machine at a slow rate of speed to the desired
location.
5.25.8 Once the machine is at the desired location, securely block the drums.
This will prevent the movement of the machine.
5.25.9 Turn the bypass valve clockwise in order to tighten the bypass valve.
5.25.10 Manually re-engage the parking brake by fully releasing the two
release screws.
WARNING