Operator`s manual

Maintenance RD 27
wc_tx000426gb.fm 72
5.23 General Cleaning
Stop the machine, apply the parking brake and switch off the engine.
Remove the ignition key and close the protective cover over the key
switch.
Protect the following parts with covers and adhesive tape:
• Engine cooling louvers.
• Exhaust pipe.
• Dashboard.
• Forward-reverse lever.
• Backup alarm.
Clean the roller thoroughly with high-pressure water jet and a strong
brush. Remove all dirt, mud, and tar from the drums and bodywork.
Note: Do not spray the backup alarm directly with the high-pressure
water.
Cleaning the vehicle thoroughly will show any oil leaks, loose nuts, or
other faults.
Particular attention should be paid to the following:
• Vent cap on the hydraulic oil tank.
• Fuel filler cap on the diesel oil tank.
• Engine compartment.
• Exciter drum shockmounts.
After washing, dry the machine with a jet of compressed air and then
remove the protective covers and tape.