Operator`s manual

RD 27 Safety Information
wc_si000147gb.fm 5
2.1 Operating Safety
Familiarity and proper training are required for the safe operation of
equipment. Equipment operated improperly or by untrained personnel
can be dangerous. Read the operating instructions contained in both
this manual and the engine manual and familiarize yourself with the
location and proper use of all controls. Inexperienced operators should
receive instruction from someone familiar with the equipment before
being allowed to operate the machine.
2.1.1 ALWAYS wear protective clothing appropriate to the job site when
operating equipment.
2.1.2 ALWAYS remain aware of moving parts and keep hands, feet, and
loose clothing away from the moving parts of the equipment.
2.1.3 ALWAYS read, understand, and follow procedures in the Operator’s
Manual before attempting to operate the equipment.
2.1.4 ALWAYS store the equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the reach of
children.
2.1.5 ALWAYS check that all controls are functioning properly immediately
after start-up! DO NOT operate machine unless all controls operate
correctly.
2.1.6 ALWAYS operate the machine with all safety devices and guards in
place and in working order.
2.1.7 ALWAYS remain aware of changing positions and movement of other
equipment and personnel on the job site.
2.1.8 ALWAYS remain aware of changing surface conditions and use extra
care when operating over uneven ground, on hills, or over soft or
coarse material. The machine could shift or slide unexpectedly.
2.1.9 ALWAYS use caution when operating near the edges of pits, trenches
or platforms. Check to be sure ground surface is stable enough to
support the weight of the machine and operator and there is no danger
of the machine sliding, falling or tipping.
2.1.10 ALWAYS be sure that all other persons are at a safe distance from the
machine. Stop the machine if people step into the working area of the
machine.
2.1.11 ALWAYS disengage and stow the locking bar for the articulated
steering joint before operating the machine. The machine cannot be
steered when the locking bar is engaged.
2.1.12 DO NOT attempt to start the machine when standing alongside it. Only
start the engine when seated in the driver's seat and with the forward/
reverse control in the neutral position.
WARNING