Operator`s manual

Operation RD 27

wc_tx000425gb.fm 40

4.22 Starting the Engine

See graphic: wc_gr002312, wc_gr002311, wc_gr002229, and wc_gr002582

Exhaust gases are toxic. Do not start the engine in enclosed spaces.

4.22.1 Sit down in the operator’s seat and fasten seat belt.

4.22.2 Move forward-reverse (f) lever to neutral position.

4.22.3 Push parking brake knob (h) downward to engage parking brake.

4.22.4 Move throttle to the LOW position (1).

4.22.5 Insert the ignition key into the ignition switch in “Position 0”.

4.22.6 Turn the ignition key to “Position 1”. Check for power to the control

panel. The oil pressure and alternator lights should illuminate.

4.22.7 Turn the ignition key to “Position 2” and hold it there for approximately

15 seconds to supply power to the glow plugs. In warmer weather the

time period may be reduced.

4.22.8 Immediately after powering the glow plugs, turn the key to ’Position 3”

to crank the engine. When the engine fires, immediately release the

ignition key to avoid straining the starter motor. When you release the

ignition key, it will return automatically to “Position 1”.

4.22.9 The hour meter will begin to function when the engine fires and starts

running.

Prolonged exposure to high noise levels can damage your hearing.

Wear appropriate hearing protection while operating the roller.

Observe the following recommendations for engine warm-up when

operating at the listed temperatures:

• Above 0°C (32°F), the warm-up period is 15 minutes.

• Below 0°C (32°F), the warm-up period is 30 minutes or longer.

• Below -18°C (0°F), more time is required if the hydraulic controls

are sluggish.

Before moving the machine:

• Check the operation of the parking brake with the engine running.

• Check the operation of the steering system with the engine

running.

• Check that the vehicle's exhaust system is in good working order

and that there are no leaks.

• Make sure that no one is in the vehicle's path.

WARNING